H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 217)

26-22
Figure 26-21 Network diagram for DHCP relay agent configuration
Configuration procedure
1) Specify IP addresses for interfaces (omitted)
2) Configure the DHCP relay agent
# Enable DHCP.
Select Network > DHCP from the navigation tree to enter the default DHCP Relay page. Perform
the following operations, as shown in Figure 26-22 .
Figure 26-22 Enable DHCP
Click on the Enable radio button next to DHCP Service.
Click Apply.
# Configure a DHCP server group.
In the Server Group field, click Add. Perform the following operations, as shown in Figure 26-23 .