Configuration procedure – H3C Technologies H3C WX6000 Series Access Controllers User Manual
Page 336
32-27
Figure 32-42 Bind radios to the mesh service
On Radio 1 of the MPP, configure Radio 1 of MP 1 as the peer MAC address. Similarly, configure
Radio 1 of the MPP as the peer MAC address on MP 1. Perform the same operation for Radio 2 of
MP 1 and Radio 1 of MP 2.
2) Configure the access service
As the multi-beam antenna, Radio 3 provides the wireless access service. For related configuration,
Wireless Access Configuration Examples
. You can strictly follow the configuration example to
configure the access service.
Configuration procedure
The mesh configuration here is similar to a common wireless mesh configuration. For details, refer to
.
This manual is related to the following products: