Figure 31-36 – H3C Technologies H3C WX6000 Series Access Controllers User Manual
Page 286

31-32
Figure 31-36 Enable wireless service
Select the service1 check box.
Click Enable.
3) Bind an AP radio to a wireless service
Select Wireless Service > Access Service from the navigation tree, and click Bind at the right side of
the wireless service service1 to enter the page for binding an AP radio, as shown in
:
Figure 31-37 Bind an AP radio
Select the check box before ap with radio mode 802.11g.
Click Bind.
Select AP > AP Setup from the navigation tree to the see the AP is in IDLE state.
Figure 31-38 AP status before auto AP is enabled
4) Enable auto AP
Select AP > Auto AP from the navigation tree to enter the page for configuring auto AP, as shown in
This manual is related to the following products: