H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 443)

38-8
Task Description
Configuring RADIUS
Parameters
Required
Configure the parameters that are necessary for information exchange between the
device and RADIUS servers.
Configuring RADIUS Servers
From the navigation tree, select Authentication > RADIUS. The RADIUS server configuration page
appears, as shown in Figure 38-5 .
Figure 38-5 RADIUS server configuration
Table 38-4 lists the RADIUS server configuration items.
Table 38-4 RADIUS server configuration
Item Description
Server Type
Specify the type of the server to be configured, which can be Authentication
Server and Accounting Sever.
Primary Server IP
Specify the IP address of the primary server.
If no primary server is specified, the text box displays 0.0.0.0.
To remove the previously configured primary server, enter 0.0.0.0 in the text
box.
The specified IP address of the primary server cannot be the same as that of
the secondary server.
Primary Server Shared Key
Specify the shared key of the primary server. The primary server shared key
can be different from the secondary server shared key.
Primary Server UDP Port
Specify the UDP port of the primary server.
If the IP address of the primary server is not specified or the specified IP
address is to be removed, the port number is 1812 for authentication or 1813
for accounting.
Primary Server Status
Set the status of the primary server, including:
active: The server is working normally.
blocked: The server is down.
If the IP address of the primary server is not specified or the specified IP
address is to be removed, the status is blocked.