H3C Technologies H3C WX6000 Series Access Controllers User Manual
Page 345
33-9
For how to configure the authentication mode, refer to Wireless Service. However, fast roaming can be
implemented only when the RSN+802.1x authentication mode is adopted.
Click Apply.
# Enable wireless service
Select Wireless Service > Access Service.
Select the Roam check box.
Click Enable.
3) Bind AP radios to the wireless service
Select Wireless Service > Access Service, and click Bind at the right side of the wireless service
Roam to enter the page for binding AP radio, as shown in
:
Figure 33-10 Bind AP radios
Select the check box before ap1 with radio type being 802.11g, and the check box before ap2 with
radio type being 802.11n(2.4GHz).
Click Bind.
4) Enable dot11g radio
Select Radio > Radio Setup from the navigation tree to enter the radio setup page shown in