H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 133)

18-13
Table 18-8 Configuration items for adding a target host
Item Description
Destination IP
Address
Set the destination IP address.
Select the IP address type: IPv4 or IPv6, and then type the corresponding IP address in
the text box according to the IP address type.
Support IPv6 depends on the device model.
Security Name
Set the security name, which can be an SNMPv1 community name, an SNMPv2c
community name, or an SNMPv3 user name.
UDP Port
Set UDP port number.
The default port number is 162, which is the SNMP-specified port used for receiving traps
on the NMS. Generally (such as using iMC or MIB Browser as the NMS), you can use the
default port number. To change this parameter to another value, you need to make sure
that the configuration is the same with that on the NMS.
Security Model
Select the security model, that is, the SNMP version, which must be the same with that
running on the NMS; otherwise, the NMS cannot receive any trap.
Security Level
Set the authentication and privacy mode for SNMP traps when the security model is
selected as v3. The available security levels are: no authentication no privacy,
authentication but no privacy, and authentication and privacy.
Return to SNMPv1 or SNMPv2c configuration task list or SNMPv3 configuration task list .
SNMP Configuration Examples
Network requirements
As shown in Figure 18-17 , the NMS connects to the agent, an AC, through an Ethernet.
The IP address of the NMS is 1.1.1.2/24.
The IP address of the VLAN interface on the AC is 1.1.1.1/24.
The NMS monitors the agent using SNMPv3. The agent reports errors or faults to the NMS.
Figure 18-17 Network diagram for SNMP configuration
Configuration procedure
1) Configure the agent
# Configuration IP addresses for the interfaces. (Omitted)
# Enable SNMP.
Select Device > SNMP from the navigation tree, and you will enter the Setup page, then perform the
following configuration as shown in Figure 18-18 .