H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 448)

38-13
Configuration procedure
Enable the Telnet server function, and configure the AC to use AAA for authentication, authorization
and accounting of Telnet users. (Omitted)
1) Configure IP addresses for the interfaces. (Omitted)
2) Configure RADIUS scheme system
# Configure the RADIUS authentication server.
From the navigation tree, select Authentication > RADIUS. The RADIUS server configuration
page appears.
Figure 38-8 Configure the RADIUS authentication server
Perform the following configurations, as shown in Figure 38-8 .
Select Authentication Server as the server type.
Enter 10.110.91.146 as the IP address of the primary authentication server
Enter 1812 as the UDP port of the primary authentication server.
Select active as the primary server status.
Click Apply.
# Configure the RADIUS accounting server.