H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 332)

32-23
Select Wireless Service > Mesh Service from the navigation tree, and click the Mesh Policye tab to
enter the mesh policy configuration page, as shown in Figure 32-35 :
Figure 32-35 Mesh policy configuration page
A mesh policy exists by default. You can create a mesh policy and bind the mesh policy to an AP as
needed. By default, the default_mp_plcy mesh policy is mapped to an AP.
4) Mesh global setup
# Configure an MKD-ID (By default, the MKD-ID exists. Therefore, this step is optional.)
Select Wireless Service > Mesh Service from the navigation tree, and click the Global Setup tab to
enter the mesh global setup page, where you can set the MKD-ID.
# Enable mesh portal service
Figure 32-36 Mesh portal service configuration page
Select the MPP that has wired connectivity with the AC.
Click Enable.
5) Configure the same working channel and enable the radio on the MAP and MPP.
# Configure the working channel.