H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 157)

21-11
Figure 21-15 The Port tab
Figure 21-16 Modify a port
Make the following configurations on the page:
Select the Tagged option.
Type 2,6-50 for VLAN ID.
Click Apply and a dialog box appears, asking you to confirm that interface GigabitEthernet 1/0/1 be
changed to a hybrid port. Click OK to confirm the operation.
2) Configure AC 2
Configure AC 2 as you configure AC 1.
Configuration Guidelines
When configuring VLAN, note that:
VLAN 1 is the default VLAN, which cannot be manually created or removed.
Some VLANs are reserved for special purposes. You cannot manually create or remove them.
As shown in Figure 21-4 ., on the VLAN configuration page, when you type a VLAN range in the
VLAN Range box and then click Select, the table below lists the information about all the VLANs
within this range, which makes the operation much easier when the device contains a large number
of VLANs; when you click Delete, all VLANs within this range will be removed.
Dynamic VLANs cannot be manually removed.