H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 27)

4-4
Feature Matrix for the WX3000 Series
The access controller engine and switching engine on the WX3000 series adopt the OAP architecture.
The switching engine is integrated on the access controller engine as an OAP card. You actually log in
to the access controller engine when you log in to the device by default. GE 1/0/1 interfaces on the
WX3024, WX3010 and WX3008 are used to exchange data, status and control information with
GE1/0/29 (WX3024), GE1/0/11 (WX3010) or GE1/0/9 (WX3008) on the switching engine. Therefore,
you are not recommended to configure services such as QoS rate limiting and 802.1X authentication on
these interfaces.
Table 4-3 Feature matrix for the WX3000 series
Module Feature WX3024 WX3010 WX3008
Summary Summary IPv6 not supported IPv6 not supported IPv6 not supported
License
The WX3024
supports 24
concurrent APs by
default, and can
be extended to
support 48
concurrent APs.
The WX3010 supports 12
concurrent APs by default,
and can be extended to
support 24 concurrent
APs.
Not supported
File
management
Flash supported Flash supported Flash supported
Interface
management
Configuration of
IPv6 address for
an interface is not
supported.
Configuration of IPv6
address for an interface is
not supported. Configuration of IPv6
address for an interface is
not supported.
Port mirroring Not supported Not supported Not supported
SNMP
IPv6 destination
addresses not
supported
IPv6 destination
addresses not supported IPv6 destination
addresses not supported
Device
Loopback test
Internal loopback
testing supported
on GE interfaces
only
Internal loopback testing
supported on GE
interfaces only Internal loopback testing
supported on GE
interfaces only
IPv6 routing Not supported Not supported Not supported
Network
Diagnostic
tools IPv6 ping not
supported
IPv6 ping not supported IPv6 ping not supported
ACL IPv6 Not supported Not supported Not supported
QoS
Line rate Not supported Not supported Not supported
Advanced AC backup Not supported Not supported Not supported
High
availability
Stateful failover Not supported Not supported Not supported