Rockwell Automation 1757-SWKIT4000 ProcessLogix R400.0 Installation and Upgrade Guide - Manual (Page 87)

Publication 1757-IN040B-EN-P - March 2002
ProcessLogix Server Installation Procedures 3-19
Navigate in Knowledge Builder to:
Ethernet Implementation Guide
⇒
Configuration
⇒
Setting Up
Drivers and IP Addresses for more information.
2. Configure the IP Address for each controller.
Navigate in Knowledge Builder to:
Ethernet Implementation Guide
⇒
Configuration
⇒
Setting Up
Drivers and IP Addresses
⇒
Configuring and setting IP address
for Ethernet module section for more information.
3. Configure RSLinx drivers.
Navigate in Knowledge Builder to:
Ethernet Implementation Guide
⇒
Configuration
⇒
Setting up
Drivers ans IP Addresses
⇒
Configuring additional RSLinx drivers
for more information.
Completing the
ProcessLogix R400.0 Install
on a Redundant Server Pair Refer to Completing the ProcessLogix R400.0 Setup on a Redundant
Server Pair on page 6-1.
TIP
A driver must be configured for each controller.
IMPORTANT
If you are installing ProcessLogix software on a
redundant Server pair:
1. Return to the beginning of Configuring RSLinx
Drivers for ControlNet Supervisory Network on
page 3-13 and repeat for SERVERB.
2. Once you have configured RSLinx drivers on
both SERVERA and SERVERB, continue with
Completing the ProcessLogix R400.0 Setup on a
Redundant Server Pair on page 6-1.
If you are installing ProcessLogix R400.0 software on
a Non-redundant server, continue with Completing
the ProcessLogix R400.0 Install on a Non-Redundant
Server on page 3-20.