Rockwell Automation 1757-SWKIT4000 ProcessLogix R400.0 Installation and Upgrade Guide - Manual (Page 42)

Publication 1757-IN040B-EN-P - March 2002
2-16 Operating System Installation Procedures
Navigate in Knowledge Builder to ProcessLogix R400.0
Installation Guide
⇒
Network Planning Guide for more
information.
In some organizations, it is important that these addresses are
controlled by the IT organization. Consult your company’s
practices and IT organization for the appropriate IP address
information. It will be necessary to use valid IP information to
integrate the ProcessLogix Control system with the Business
Network.
The following Private Networking IP Address scheme can be
utilized for the system to operate:
First Client Addressing:
NIC 1: 192.168.0.3, NIC 2: 192.168.1.3
Additional Station Addressing:
NIC 1: 192.168.0.x, NIC 2: 192.168.1.x, where x is the Station
number +2. (for Station Number 2, x=4)
•
Fill in the appropriate Subnet Mask.
All configurations use a Subnet Mask of 255.255.255.0 and a
blank Default Gatetway.
•
If necessary, fill in the appropriate Default gateway.
•
Click OK to return to the Networking Components window.
18. Click Next.
19. Repeat steps 15 to 17 for additional network cards.
20. At the Workgroup of Computer Domain window:
•
Choose the No, this computer …. option
•
Enter an appropriate WorkGroup Name.
•
Click Next.
ATTENTION
!
All systems which are configured for this Process
Control System should utilize the same Workgroup
Name for easier operations.