Rockwell Automation 1757-SWKIT4000 ProcessLogix R400.0 Installation and Upgrade Guide - Manual (Page 258)

Publication 1757-IN040B-EN-P - March 2002
11-6 Performance and Capacity Specifications
ProcessLogix Server Platform Requirements
Application Usage
Server configuration memory allocations assume Server services only.
Station Client memory usage already includes the ProcessLogix Client
Applications. However, most applications can be run on either the
Servers or Station Clients. On small to medium systems, these
applications may be run on the Server Platforms. On large systems,
the Servers should be dedicated to running only the Server Services.
On these systems, when possible, all applications should be run from
the Client stations.
Using the Platform Requirement’s Table as a base for memory usage,
add on the memory requirements for each of the applications from the
table below intended to be used on a regular basis. Refer to Footnote
(1) for more information.
Table 11.C ProcessLogix Server Platform Requirements
Feature: Requirement:
Processor Dual 1 GHz Pentium III or Larger
RAM (Win 2000 Server)
384 MB (2)
(2) In these configurations, paging may occur on these systems. Based on the intended usage of the platform, this
configuration is acceptable. For better performance, users should upgrade the systems with an additional 64 MB
of RAM.
Networking 100 Mb Ethernet
Video Resolution (1)
(1) The Video Memory required to support this resolution varies by Video Module type, PC Bus supported, and
Manufacturers Spec. Please refer to Video Card Specifications for details. All systems should be set 1024 x 768
with 65K colors. MHz setting should be set to match the monitor.
1024 x 768 65K colors
Hard Drive 18.2 GB
Example Hardware Dell PowerEdge 1400
TIP
Failure to add additional memory may result in
degradation of system performance.