Rockwell Automation 1757-SWKIT4000 ProcessLogix R400.0 Installation and Upgrade Guide - Manual (Page 188)

Publication 1757-IN040B-EN-P - March 2002
8-14 Supplementary Procedures
Installing and Running
VirusScan with
ProcessLogix
About VirusScan
Problems with starting up and synchronizing Servers and crashing of
the VirusScan program can result from running the VirusScan
concurrently with the ProcessLogix software unless the VirusScan is
specifically installed and run as described in this section.
The problems noted above have occurred with version 4.0.2 of
Network Associates (formerly known as McAfee) VirusScan NT, when
running automatically upon startup or during file access.
If the Network Associates VirusScan NT program is already installed
on your ProcessLogix Server, go to the next section to remove it.
Otherwise, go to the section entitled Installing VirusScan NT and
configuring directories for scan exclusion.
Removing Existing VirusScan NT Program
If Network Associates VirusScan NT program is currently installed on
the ProcessLogix Server, use the following procedure to remove it
from the PC.
1. Click Start
⇒
Programs
⇒
Network Associates VirusScan
NT
⇒
Uninstall VirusScan NT.
2. Click Yes to confirm the action and follow the on-screen
instructions on the Uninstall Wizard to remove the VirusScan NT
program.
3. When the uninstall is completed, restart the PC.
IMPORTANT
If you need to run the Network Associates VirusScan
NT application on a ProcessLogix Server, you must
install and run the application as described in this
section.