beautypg.com

Adding pcic hardware device drivers, Moving the rslinx activation file, About the activation file – Rockwell Automation 1757-SWKIT4000 ProcessLogix R400.0 Installation and Upgrade Guide User Manual

Page 78: About the activation file -10

background image

Publication 1757-IN040B-EN-P - March 2002

3-10 ProcessLogix Server Installation Procedures

25. Click the No, I will restart my computer later option and click

Finish.

Adding PCIC Hardware
Device Drivers

If you have not yet configured your 1784-PCIC card, a Found New
Hardware Wizard will appear after restart. If you need to configure
your 1784-PCIC card, refer to Install Hardware Device Drivers on
page 7-1.

Moving the RSLinx
Activation File

About the Activation File

Use the following procedure to move the activation file (evrsi.sys)
from the RSLinx software Master Disk to the hard drive where RSLinx

ATTENTION

!

If you are installing ProcessLogix software on a
redundant Server pair:

1. Do not restart SERVERA.

2. Return to the beginning of Installing ProcessLogix

Software on a Clean PC on page 3-1 and repeat
for SERVERB.

3. Once you have completed these procedures for

both SERVERA and SERVERB, restart SERVERB.

4. Logon to SERVERB as ps_user.

5. When SERVERB is running, restart SERVERA and

logon as ps_user.

6. Continue with the next section.

If you are installing ProcessLogix software on a
non-redundant Server:

1. Restart the Server.

2. Logon as ps_user.

3. Continue with the next section.