Rockwell Automation 1757-SWKIT4000 ProcessLogix R400.0 Installation and Upgrade Guide - Manual (Page 49)

Publication 1757-IN040B-EN-P - March 2002
Operating System Installation Procedures 2-23
Adjusting the Video Settings
The system applications and displays have been optimized to be
displayed at a resolution of 1024 by 768 with 65K (High Color, 16 bit).
Utilizing any other setting than this will produce anomalies in some
displays.
Set the Video Settings by performing the following tasks:
1. Right mouse click on the desktop and select Properties.
2. Choose the Settings tab.
3. Click Advanced in the lower right hand side of the window.
4. Confirm that the General Tab, the Display Font size is set to
Small Fonts.
5. Click the Adapter tab.
6. Click List All Modes.
7. Choose one of the settings entitled 1024 by 768, High Color (16
bit).
You should choose a refresh rate (listed in Hertz) at the
maximum the monitor could handle. For Example, 1024 by 768,
High Color (16 bit), 75 Hertz. Click OK after your selection.
8. Click Apply.
At this point the setting will be applied.
9. Click OK.
10. Click Yes to keep your setting.
If nothing appears or you are unable to see the screen, the
previous mode will be reset after the 15 Seconds. Reset the
mode to a lower Hertz setting and repeat the process.
11. Click OK to close the (Advanced) adapter properties Window.
12. Click OK to close the Display Properties window.