Rockwell Automation 1757-SWKIT4000 ProcessLogix R400.0 Installation and Upgrade Guide - Manual (Page 54)

Publication 1757-IN040B-EN-P - March 2002
2-28 Operating System Installation Procedures
Clean System Windows NT
4.0 Workstation Installation
Overview
Windows NT Workstation can be used for a ProcessLogix Client only.
If Windows NT is already installed on your PC, skip to Installing
Service Pack 6a for Windows NT 4.0 on page 2-35.
The current requirement is Windows NT version 4.0 (English [USA]
default) with Service Pack 6a, Internet Explorer 5.5 SP1, and MDAC
2.5. The Windows NT software is a licensed product of Microsoft
Corporation. A copy of Service Pack 6a, Internet Explorer 5.5 SP1 and
MDAC 2.5 are included on the ProcessLogix R400.0 software CD 2 for
your convenience.
The Windows NT software will guide you through the following
phases of installation in the order listed.
•
Starting Windows NT installation
•
Setting up Windows NT
•
Installing TCP/IP networking software
•
Setting the date and time
•
Setting up the display driver
•
Completing installation
•
Installing Service Pack 6a
•
Configuring System Properties
•
Converting to NTFS (if required) after Windows NT has been
installed
•
Setting COM ports
•
Creating an emergency repair disk
Use the manufacturer’s instructions to supplement information in the
remaining subsections, as required.
IMPORTANT
If the Windows NT boot disks are not available to
you, contact Rockwell Automation Technical Support
for more information. Refer to Rockwell Automation
Technical Support on page P-3.