Rockwell Automation 1757-SWKIT4000 ProcessLogix R400.0 Installation and Upgrade Guide - Manual (Page 40)

Publication 1757-IN040B-EN-P - March 2002
2-14 Operating System Installation Procedures
Use the entire hard disk if possible, see note below.
6. Format the partition using the NTFS file system.
Setup will format the partition. This takes a few minutes to
complete.
7. The computer will automatically reboot. Be sure to remove
floppy disk from the floppy disk drive.
8. At the Welcome to Setup window, click Next.
If there is a delay clicking next, setup will continue the
installation automatically.
9. Verify the information on the Regional Settings screen and click
Next.
10. Enter the appropriate Name and Organization name and click
Next.
11. Enter your Windows 2000 Professional Product Key and click
Next.
12. At the Computer Name and Administrator Password window:
•
Enter the Computer Name.
•
Enter the Administrator password.
ATTENTION
!
Certain PCs will limit the size of the partition that
you can create. Windows 2000 supports a boot
partition size up to a 32 Gigabytes on a NTFS
formatted drive.
If your system has a limitation, create the largest
partition you can, and leave the leftover space as
unpartitioned. (You can create and format the
unpartitioned space later.) The minimum partition
size required for this installation is 4 Gigabytes.
ATTENTION
!
The computer name cannot contain more than 14
alphanumeric characters and must contain no spaces.
For a ProcessLogix Client, be sure the name does not
end in the letter “A” or “B”. The suggested name is
STNxx, where xx is the Station Number (01-20).