Rockwell Automation 1757-SWKIT4000 ProcessLogix R400.0 Installation and Upgrade Guide - Manual (Page 31)

Publication 1757-IN040B-EN-P - March 2002
Operating System Installation Procedures 2-5
6. Press any key to boot from the CD-ROM.
Completing the Windows 2000 Server Installation
1. Press Enter on Welcome to Setup Screen.
2. If requested, insert the Windows 2000 Server CD into the
CD-ROM drive and press Enter.
3. Press F8 to agree to the Windows 2000 Licensing Agreement.
4. If necessary, press ESC(escape) to continue installing a fresh
copy of Windows 2000.
5. Press Enter to set up Windows 2000 on the Unpartitioned space.
Use the entire hard disk if possible, see note below.
6. Format the partition using the NTFS file system.
ATTENTION
!
If your installation requires additional
Manufacturer’s Drivers, press the F6 key during the
boot process and follow the on-screen instructions
for adding the necessary drivers.
ATTENTION
!
If Windows 2000 Setup did not find a suitable
installation device, it will stop and prompt you for
additional Manufacturer’s Drivers. Follow the
on-screen instructions for adding the necessary
drivers.
ATTENTION
!
If existing partitions are found, delete all of them
first before proceeding. Use the on-screen
instructions to perform this task.