Rockwell Automation 1757-SWKIT4000 ProcessLogix R400.0 Installation and Upgrade Guide - Manual (Page 152)

Publication 1757-IN040B-EN-P - March 2002
6-18 Additional Redundant Server Procedures
b. Select the Station type as Static Station.
c. Key in >2< as the Static Station Number and click Advanced.
d. Check the Auxiliary setup file checkbox.
e. Browse and navigate to:
C:\Honeywell\Client\Station\defaultb.stn and click Open.
14. Click Save.
15. Click Yes to save changes.
16. Highlight Default and click connect.
17. Click Cancel at the Unable to connect prompt, if applicable.
18. If you have redundant LANs, you must repeat Step 1 through
Step 17 to set up files for the second LAN using the name or IP
address of the SERVERA and SERVERB nodes specified in the
Hosts file for the second LAN
.
19. Click Station
⇒
Exit.
20. Click Yes to exit Station.
Setting Up Station on
SERVERA 1. On SERVERA, click Start
⇒
Programs
⇒
ProcessLogix
Server
⇒
Station.
2. Click Cancel at the Unable to connect prompt, if applicable.
3. Click Station
⇒
Connect to call up the Station Connect dialog
box.
IMPORTANT You must indicate the full path to the .stn file.
EXAMPLE
For example, the Secondary Server (SERVERB) name
would be PLX1B1 based on a Server name of
PLX1B in Step 5 and the Primary (SERVERA) name
would be PLX1A1 based on a Server name of
PLX1A in Step 13.
Refer to the Server and Client Configuration Guide
in Knowledge Builder for more information.
The Server names used are for example purposes
only and must not be used in place of your actual
Server names.