Rockwell Automation 1757-SWKIT4000 ProcessLogix R400.0 Installation and Upgrade Guide - Manual (Page 144)

Publication 1757-IN040B-EN-P - March 2002
6-10 Additional Redundant Server Procedures
a. With the Full Mode version of the dialog box active, click the
System Running option.
b. Click Yes to confirm the action and wait for the Server to
change its state.
c. Close the ProcessLogix Server dialog box.
Setting Up Secondary
Server (SERVERB) Node Use the following procedures to set up the Secondary SERVERB
node.
Making Redundant Hardware File Entries
Refer to Making Redundant Hardware File Entries on page 6-6 and
repeat the procedures on SERVERB. Change the reference in Step 1
from SERVERB to SERVERA and in Step 2 from SERVERA to
SERVERB. Be sure you are working on the SERVERB node.
Configuring the Time Service
Refer to Configuring the Time Service on page 6-8 and repeat the
procedures on SERVERB. Be sure you are working on the SERVERB
node.
Confirming Data Link is Available
1. On SERVERA, click Start
⇒
Run.
2. Key in this command in the Open entry field:
>cmd<
and click OK to open the DOS window.
3. At the DOS prompt, key in this command:
>dual_status<
and press .