Rockwell Automation 1757-SWKIT4000 ProcessLogix R400.0 Installation and Upgrade Guide - Manual (Page 140)

Publication 1757-IN040B-EN-P - March 2002
6-6 Additional Redundant Server Procedures
Setting up Primary Server
(SERVERA) node
Use the following procedures to set up the Primary SERVERA node.
Making Redundant Hardware File Entries
1. On the SERVERB node, click Start
⇒
Programs
⇒
ProcessLogix
Server
⇒
Start-Stop ProcessLogix Server to call up the
ProcessLogix Server dialog box. Check that the Server is
running. Close the dialog box.
OR
2. On the SERVERA node, click Start
⇒
Programs
⇒
ProcessLogix
Server
⇒
Start-Stop ProcessLogix Server to call up the
ProcessLogix Server dialog box.
a. With the Full Mode version of the dialog box active, verify
that the Server is in Database Only. If it is not, click the
Database Only option.
ATTENTION
!
Failure to convert the existing non-redundant Server
to the SERVERA redundant node will result in loss of
configuration data. This will require reconfiguring
the system.
TIP
To display the “Full Mode” version of the
ProcessLogix Server dialog box, click the icon to the
left of ProcessLogix in the title bar and click
Advanced
⇒
Full Mode. A checkmark will now
appear in front of the Full Mode selection to show
that it is active.