Rockwell Automation 1757-SWKIT4000 ProcessLogix R400.0 Installation and Upgrade Guide - Manual (Page 85)

Publication 1757-IN040B-EN-P - March 2002
ProcessLogix Server Installation Procedures 3-17
Reconfiguring RSLinx Drivers for ControlNet Supervisory Network
Use the following procedure to reconfigure the 1784-PCIC drivers for
RSLinx.
1. Click Start
⇒
Programs
⇒
Rockwell Software
⇒
RSLinx
⇒
RSLinx to
call up the Rockwell Software RSLinx window.
2. Click Communications
⇒
Configure Drivers to call up the
Configure Drivers dialog box.
3. Click the 1784-PCIC(S) for ControlNet devices selection in the
Available Drivers list box and click Add New to call up the Add
New RSLinx Driver dialog box.
4. Click OK to accept the default name AB_PCIC-1 for the driver.
a. Serial Number(hex): This value is read from the PCIC card
and does not change.
b. Network Address(dec): Change the default of 99 to:
•
Non-redundant Server 24
•
Redundant Server A 24
•
Redundant Server B 23
3. Click OK to close the dialog box and start the PCIC driver.
IMPORTANT The driver name MUST be AB_PCIC-1