beautypg.com

Restarting redundant servers, Restarting redundant servers -21 – Rockwell Automation 1757-SWKIT4000 ProcessLogix R400.0 Installation and Upgrade Guide User Manual

Page 155

background image

Publication 1757-IN040B-EN-P - March 2002

Additional Redundant Server Procedures 6-21

e. Browse and navigate to:

C:\Honeywell\Client\Station\defaultb.stn and click Open.

14. Click Save.

15. Click Yes to save changes.

16. Highlight Default and click Connect.

17. Click Cancel at the Unable to connect prompt, if applicable.

18. If you have redundant LANs, you must repeat Step 1 through

Step 17 to set up files for the second LAN using the name or IP
address of the SERVERA and SERVERB nodes specified in the
Hosts file for the second LAN

.

19. Click Station

Exit.

20. Click Yes to exit Station.

Restarting Redundant
Servers

Use the following procedure to restart SERVERA and then SERVERB.

IMPORTANT

You must indicate the full path to the .stn file.

EXAMPLE

For example, the Secondary Server (SERVERB) name
would be PLX1B1 based on a Server name of
PLX1B in Step 5 and the Primary (SERVERA) name
would be PLX1A1 based on a Server name of
PLX1A in Step 13.

Refer to the Server and Client Configuration Guide
in Knowledge Builder for more information.

The Server names used are for example purposes
only and must not be used in place of your actual
Server names.

ATTENTION

!

The following procedure assumes that you have
completed the previous procedures in this section
for both the SERVERA (Primary) and SERVERB
(Secondary) nodes.