Rockwell Automation 1757-SWKIT4000 ProcessLogix R400.0 Installation and Upgrade Guide - Manual (Page 57)

Publication 1757-IN040B-EN-P - March 2002
Operating System Installation Procedures 2-31
6. Enter a lower case computer name for your PC.
7. Record the computer name for future reference and click Next.
8. On the Administrator page, key in the password for the
Administrator account twice. The default password for
ProcessLogix systems is “password”.
9. Record the password for future reference and click Next.
10. Click No, do not create an Emergency Repair Disk and click
Next.
The Emergency Repair Disk will be created in a later procedure.
11. Click Next to install the default Windows NT components.
Installing TCP/IP Networking Software
Transmission Control Protocol/Internet Protocol (TCP/IP) is a
networking protocol that provides communication across
interconnected networks made up of ProcessLogix Servers and
ProcessLogix Clients. You must install TCP/IP networking software
even if your PC does not include a network card. You cannot run
ProcessLogix software without TCP/IP networking software.
Use the following procedure to install TCP/IP as part of the Windows
NT installation. This procedure assumes that you know the following
information relevant to your communication network.
•
The network name of your PC(s).
•
The IP address of your PC.
IMPORTANT
Be certain that the caps lock is not enabled. The
computer name must be typed in lower case. You
will notice that when you type, the computer name
displays in capital letters.
ATTENTION
!
The computer name cannot contain more than 14
alphanumeric characters and must contain no spaces.
For a ProcessLogix Client, be sure the name does not
end in the letter “A” or “B”. The suggested name is
STNxx, where xx is the Station Number (01-20).