Rockwell Automation 1757-SWKIT4000 ProcessLogix R400.0 Installation and Upgrade Guide - Manual (Page 255)

Publication 1757-IN040B-EN-P - March 2002
Performance and Capacity Specifications 11-3
Clients require a Windows NT operating system to support the
multiple-user configuration nodes architecture that is possible with
R400.0 ProcessLogix systems.
Platform System Configuration Definitions
The number of Physical Servers and Stations does not determine
system configuration. If you are considering a large and complex
process, this will affect the performance and possibly the Operating
System type you should consider. For example, you may only require
passive monitoring and occasional report generation, but the process
is large and complex. Therefore you would be better off installing
system requirements that better match the Performance system, rather
than the Typical configuration. Use the information below to
approximate your system size.
Minimum
This is the minimum hardware necessary to run the ProcessLogix
components. It should only be used for small configurations that may
consist of 1 non-redundant Server with 1 Station or a Redundant
Server pair. The system typically only includes passive monitoring and
occasional report generation.
Table P.1: Supported Hardware for ProcessLogix R400.0
Component Description
Base Dell PowerEdges 1400
Processor 1 GHz/133 256K Cache, Pentium III
Mouse Logitec System Mouse, Gray
Keyboard Quietkey 104-Key, Gray, 6 Pin
System RAM 384MB, DIMM, 133MHz 16x72, 168
CD-ROM 20/48X Black, Compact Disk Drive, IDE
Floppy Drive 1.44MB, F3, NEC P 1400
Hard Drive 18GB 10K,68P
Tape Drive 20/40G, Tape Backup Unit, Power Vault 100T, DD54
Network Intel Pro 100 Plus, NIC
I/O Expansion 3 PCI, 2 shared, 2 ISA
Operating System Microsoft Windows 2000 Server, SP2, 5 Client Access Licenses,
NTFS, All hardware component drivers