Rockwell Automation 1757-SWKIT4000 ProcessLogix R400.0 Installation and Upgrade Guide - Manual (Page 39)

Publication 1757-IN040B-EN-P - March 2002
Operating System Installation Procedures 2-13
3. When prompted, enter into the computer’s BIOS setup program.
4. Verify that the Boot Priority has the CD-ROM device listed first.
(Before the floppy or hard disk devices.)
5. Exit the BIOS and save the setting.
6. Press any key to boot from the CD-ROM.
Completing the Windows 2000 Professional Installation
1. Press Enter on Welcome to Setup Screen.
2. If requested, insert the Windows 2000 Professional CD into the
CD-ROM drive and press Enter.
3. Press F8 to agree to the Windows 2000 Licensing Agreement.
4. If necessary, press ESC(escape) to continue installing a fresh
copy of Windows 2000.
5. Press Enter to set up Windows 2000 on the Unpartitioned space.
ATTENTION
!
If your installation requires additional
Manufacturer’s Drivers, press the F6 key during the
boot process and follow the on-screen instructions
for adding the necessary drivers.
ATTENTION
!
If Windows 2000 Setup did not find a suitable
installation device, it will stop and prompt you for
additional Manufacturer’s Drivers. Follow the
on-screen instructions for adding the necessary
drivers.
ATTENTION
!
If existing partitions are found, delete all of them
first before proceeding. Use the on-screen
instructions to perform this task.