Configuring unix cim extensions, To run behind firewalls – HP Storage Essentials NAS Manager Software User Manual
Page 684
Troubleshooting
652
• 1234 the new port for the CIM Extension
3.
Save the file.
4.
Restart the CIM Extension for your changes to take effect.
NOTE:
The CIM Extension looks for parameters in the cim.extension.parameters
file whenever it starts, such as when it is started manually or when the host is rebooted.
5.
The management server assumes the CIM Extension is running on port 4673. If you change the
port number, you must make the management server aware of the new port number.
Discovery from HP SIM
Enter the port number on the System Protocol Settings page (Options > Protocol Settings >
System Protocol Settings
) under the WBEM section. Refer to the SIM documentation for
more information.
Discovery from HP SE
In the IP Address/DNS Name field in the Add Address for Discovery page (Discovery >
Setup
> Add Address on the HP SE Home page), type a colon and then the port number after
the IP address or DNS name, as shown in the following example:
192.168.1.2:1234
where
• 192.168.1.2 is the IP address of the host
• 1234 is the new port number
If you have already added the host to the discovery list (Discovery > Setup on the HP SE
Home page
) on the management server, you must remove it and then re-add it. You cannot
have more than one listing of the host with different ports.
Configuring UNIX CIM Extensions
to Run Behind Firewalls
In some instances you will need to discover a host behind a firewall. Use the following table as a
guideline. Assume the management server wants to discover HostA, which has three network
interface cards on three separate networks with three separate IPs: 10.250.250.10,
172.31.250.10, and 192.168.250.10. In the following table different configurations are
presented:
•
The “Manual Start Parameters for CIM Extensions” column provides what you would enter to
start the CIM Extension manually on the host. See the Installation Guide for more information on
how to start a CIM Extension manually.
•
The “If Mentioned in cim.extension.parameters” column provides information on how you
would modify the cim.extension.parameters file. See ”
Permanently Changing the Port a
CIM Extension Uses (UNIX Only)
•
(Discovery from HP SE Only)The “Step 1 Discovery (Discovery > Setup from the HP SE Home
page) and RMI Registry Port” column - Provides information about what IP addresses are
required for the discovery list. The RMI Registry port is the port the CIM Extension uses. Keep in
mind that when a port other than 4673 is used for the CIM Extension, the port must be included
- Storage Essentials Report Designer Software Storage Essentials Global Reporter Software Storage Essentials Exchange Viewer Software Storage Essentials Chargeback Manager Software Storage Essentials Enterprise Edition Software Storage Essentials File System Viewer Software Storage Essentials Backup Manager Software Storage Essentials Provisioning Manager Software