HP Storage Essentials NAS Manager Software - Manual (Page 128)

Discovering NAS Devices, Tape Libraries, Switches and Storage Systems 96
“Discovery->Setup in Troubleshooting mode” link located in the step 1 error message. Clicking
this link will bring you to the step 1 page with Troubleshooting Mode enabled.
NOTE: Step 3 Troubleshooting Mode only identifies quarantined hosts.
When Troubleshooting Mode is enabled during discovery step 2 or 3, the following additional
information is provided to assist in the identification of configuration issues:
• Host OS
• CIM Extension Version
• HBA (Driver Version)
• Multipathing
Managing McDATA and EMC Connectrix Switches
This section describes the following:
• ” About Managing McDATA and EMC Connectrix Switches ” on page 95
• ” Adding McDATA and EMC Connectrix Switches ” on page 96
• ” (Discovery from HP SE Only)Removing McDATA and EMC Connectrix Switches ” on page 96
• ” (Discovery from HP SE Only)Swapping McDATA and EMC Connectrix Switches ” on page 97
About Managing McDATA and EMC Connectrix Switches
Whenever you add, remove or replace McDATA or EMC Connectrix switches in an already
discovered service processor, you must make the management server aware of those changes.
After you add these switches to the service processor, you must perform Get Details/Discovery
Data Collection. The management server obtains information about the new switches from the
service processor. See the topic, ” Adding McDATA and EMC Connectrix Switches ” on page 96
for more information about adding switches.
(Discovery from HP SE only)When you remove switches from the service processor, you must
remove them from the management server as well. See the topic, ” (Discovery from HP SE
Only)Removing McDATA and EMC Connectrix Switches ” on page 96 for more information about
removing switches. When you replace McDATA or EMC Connectrix switches, you add and
remove the switches as described previously. See the topic, ” (Discovery from HP SE
Only)Swapping McDATA and EMC Connectrix Switches ” on page 97 for more information.
Adding McDATA and EMC Connectrix Switches
After you add switches to an existing service processor, you must perform Get Details/Discovery
Data Collection, as described in the following steps. If you are adding switches to a service
processor that has not been discovered yet, see the topic, ” Discovering McDATA and EMC
Connectrix Switches ” on page 45.