HP Storage Essentials NAS Manager Software - Manual (Page 123)

Storage Essentials 5.1 User Guide 91
• ” Excluding EMC Symmetrix Storage Systems from Force Device Manager Refresh ” on page 92
• ” Excluding HDS Storage Systems from Force Device Manager Refresh ” on page 93
Get Details or Discovery Data Collection
Get Details or Discovery Data Collection is required to obtained detailed information from
discovered elements. Get Details/Discovery Data Collection must be performed before you can do
provisioning and/or obtain provisioning information, such as data about zone sets and LUN
numbers.
Keep in mind the following:
• Get Details/Discovery Data Collection takes some time. You might want to perform this process
when the network and the managed elements are not busy. (Discovery from HP SE only)To
obtain a picture of device connectivity quickly, click the Get Topology button on the Topology
tab.
• During Get Details/Discovery Data Collection the topology in System Manager is recalculated.
While the topology is being recalculated, the loading of the user interface in Storage Essentials
may be slow.
• If you have problems obtaining information from Connectrix and McDATA switches during Get
Details/Discovery Data Collection, see the topic, ” Step 2 - Discover Storage Systems, NAS
Devices and Tape Libraries ” on page 58.
• You can use discovery groups to break up getting the topology (Discovery from HP SE only) or
Get Details/Discovery Data Collection. For example, instead of Get Details/Discovery Data
Collection for all of the elements, you could specify that the management server Get
Details/Discovery Data Collection for only the elements in Discovery Group 1, thus, saving you
time. You add an element to a discovery group by modifying the properties used to discover the
element. See ” Moving Elements to Another Discovery Group ” on page 98 for information on
how to move one or more multiple elements to a discovery group. You can also move an
element to another discovery group when you modify its discovery properties. See ” Modifying
the Properties of a Discovered Address ” on page 86.
• When an element in a given discovery group is updated, its dependent elements are also
updated. For example, assume Host_A is the only element in Discovery Group 1. Host_A is
connected through a switch and storage system. When you Get Details/Discovery Data
Collection for Discovery Group 1, you also obtain details from the switch and storage system.
• You can quarantine elements to exclude them from Get Details/Discovery Data Collection. See
” Placing an Element in Quarantine ” on page 99 for more information. Let us assume you want
to discover all the elements in a discovery group, except for one. Perhaps the element you want
to quarantine is being taken off the network for maintenance. You can use the quarantine
feature to exclude one or more elements from discovery.
• If you want to receive status reports about Get Details/Discovery Data Collection, see
” Configuring E-mail Notification for Discovery Data Collection/Get Details ” on page 660 for
information about how to configure this option.
• If the management server unable to obtain information from a UNIX host during Get
Details/Discovery Data Collection as a result of a CIM Extension hanging, the management
server places the access point where the CIM Extension is located in quarantine. The
management server then moves onto getting details for the next element in the Get