Renesas H8S/2111B - Manual (Page 150)

Rev. 1.00, 05/04, page 116 of 544
• P61/FTOA/KIN1
The pin function is switched as shown below according to the combination of the OEA bit in
TOCR of the FRT, and the P61DDR bit.
OEA 0 1
P61DDR 0 1 —
P61 input pin P61 output pin FTOA input pin Pin Function
KIN1 input pin*
Note: * This pin can always be used as the
KIN1 input pin.
• P60/FTCI/KIN0/TMIX
P60DDR 0 1
P60 input pin P60 output pin Pin Function
FTCI input pin, TMIX input pin,
KIN0 input pin*
Note: * This pin is used as the FTCI input pin when an external clock is selected with bits CKS1
and CKS0 in TCR of the FRT. It can always be used as the
KIN0 input pin. When the
IOSX bit in TCRXY of TMR_X is set to 0, this pin can be used as the TMIX input pin.
7.6.6 Port 6 Input Pull-Up MOS
Port 6 has an on-chip input pull-up MOS function that can be controlled by software. This input
pull-up MOS function can be specified as on or off on a bit-by-bit basis.
When a pin is designated as an on-chip peripheral module output pin, the input pull-up MOS is
always off.
Table 7.5 summarizes the input pull-up MOS states.
Table 7.5 Input Pull-Up MOS States (Port 6)
Reset Hardware Standby Mode Software Standby Mode In Other Operations
Off Off On/Off On/Off
[Legend]
Off:
Input pull-up MOS is always off.
On/Off: On when the pin is in the input state, P6DDR = 0, and KMPCR = 1; otherwise off.