Metrohm tiamo 1.1 Manual - Manual (Page 759)

Subwindow Sensors 731
Next calibration
Date on which the next calibration is to be carried out. If calibration data
monitoring is switched on and if the set date is before the current date (i.e.
the calibration has not yet been carried out) then the date will be shown in
red.
With the menu item Edit, Column display... further columns from the Sensor proper-
ties can be shown.
Note
Lines containing entries in red will also show the line number with a red back-
ground.
Table view
The sensor table cannot be edited directly. With a click on the column title the ta-
ble can be sorted according to the selected column in increasing or decreasing
sequence. The table view can be adapted as follows with the left-hand mouse
key:
• Drag the margin between the column titles:
Sets the column width
• Double-click on the margin between the column titles:
Sets the optimal column width
• Drag the column title:
Moves the column to the required position
If the contents of a field is larger than the column width then the whole contents
can be shown as a tooltip by keeping the mouse cursor on the field.
Functions
The menu Edit beneath the sensor table contains the following menu items:
New...
Adds a new sensor manually.
Delete
Deletes the selected sensor.
Properties...
Edits the selected sensor.
Column display...
Defines columns for the sensor table.
Print (PDF)...
Outputs the sensor table as a PDF file.