Metrohm tiamo 1.1 Manual - Manual (Page 595)

Commands 567
SEND - event messages
Receiver
[ System ], Command
Selection of the type of receiver.
Selection
Command name, [ 'empty' ]
Selection of the command which a message should be sent to. All the
commands defined in the method are available for Receiver = Command .
For Receiver = System this parameter is not editable.
Event message
[ Quit ], Hold, Stop (for Receiver = System )
[ Quit ], Hold, Continue, Start Titration (for Receiver = Command )
Selection of the event message to be sent. The following event messages
can be selected depending on the type of receiver:
Receiver Selection Event message Meaning
System - Hold
Hold determination (all tracks). Corresponds to
the button [Hold] in the dialog window Run.
System - Quit Cancel determination (Series continues).
System - Stop
Cancel determination and series. Corresponds to
the button
[Stop] in the dialog window Run.
Command
All track
commands
Hold Hold selected track.
Command
All track
commands
Continue Continue selected track.
Command
All track
commands
Quit
Cancel selected track.
If the selected track contains a command being
conditioning, conditioning is only stopped if the
option
Automatic conditioning is disabled in the
command START .
Command
All com-
mands
Hold
Hold selected command. Also valid for condition-
ing.
Command
All com-
mands
Continue
Continue selected command. Also valid for condi-
tioning.
Command
All com-
mands
Quit
Cancel selected command.
If the selected command is being conditioning,
conditioning is only stopped if the option
Auto-
matic conditioning is disabled in the command
START .
Command
SET, KFT,
KFC
Start Titration
Start titration. For this, the option Only start titra-
tion by a start command from a SEND command
must be enabled on the tab Conditioning of the
titration command (Example: KFT).