Metrohm tiamo 1.1 Manual - Manual (Page 734)

706 Configuration
Settings
Barcode reader ID
Shows the identification of the barcode reader.
Input target
[ Active input field ], Method, ID1...8, Sample size, Sample size unit, Sample po-
sition
Selection of the field into which the output from the barcode reader is to be
entered.
Tests the barcode reader connection. The dialog window Check connection
appears.
Check connection
In order to test the connection to a barcode reader, the device must be selected in
the device table and then under
Edit, Properties the properties window is opened
for this device. On the tab Settings the button [Check connection] must then be
pressed.
Opens the dialog window Check connection .
If a barcode is read in with the barcode reader then the received data will
be inserted in the following fields:
Barcode reader ID
Identifier of the barcode reader.
Data
Read-in data.