Metrohm tiamo 1.1 Manual - Manual (Page 321)

Method editor 293
5.2.5 Check method
A method check for the focused method is started with the icon or with the
menu item File, Method check . The following pints are checked:
• Are the tracks defined in CALL commands available?
• Are the targets of loop commands defined?
• Are the variables defined in calculation formulae available?
• Does a track contain more than one command with conditioning acti-
vated?
• Does a special track (Series start track, Series end track, Exit track
and Error track) contain a command with conditioning activated?
A message will be displayed for each error. The method check has to be started
again afterwards. If the method check has been successfully finished, a corre-
sponding message will be displayed.
5.2.6 Save method
An existing method is saved under the same name with the icon or with the
menu item File, Save without opening the dialog window Save method .
When saving a new method with File, Save or when saving an existing method with
File, Save as... the dialog window Save method is opened. A method group can be
selected and a method name can be entered or selected.
Method group
Method group
Method groups, [ Main group ]
Selection of the Method group where the method should be stored.
Open the window Method groups s (see Methods - Manage method groups)
for managing the method groups.
Method table
The non-editable method table contains all information of the methods of the se-
lected method group. With a click on the column title ( Name , Saved , User , Full
name , Version , Signed , Method comment ) the table can be sorted according to the
selected column in either increasing or decreasing sequence.