Metrohm tiamo 1.1 Manual - Manual (Page 449)

Commands 421
Control range
Set a large control range for steep curves and a small control range for flat ones.
A good approximation for the start of the control range is given by the point where
the tangents intersect.
STAT pH
Command for STAT titrations with measured value pH.
Devices
This command can be executed with the following devices which have the STAT
pH mode:
Titrino: 718, 736, 751, 799
Titrando: 835, 836, 842, 855
Appearance
The command has the following appearance:
Parameters
The parameters for the command STAT pH are configured in the following 8 tabs:
• General/Hardware
Parameters for devices, dosing devices, sensors and stirrers.
• Start conditions
Parameters for the measurement of the initial measured value and for
defining the conditions which have to be met at the start of the titra-
tion.
• Control parameters
Parameters for the control point.
• Titration parameters
Parameters for the run of the titration.
• Stop conditions
Definitions of conditions which cause the stop of the titration.
•
Monitoring
Definition of measured value, dosing rate, and temperature monitor-
ing.