Metrohm tiamo 1.1 Manual - Manual (Page 266)

238 Database
Save method
With this button the determination method can be saved in a method
group. The window
Save method opens in which the method group can be
selected and a method name entered or selected.
Show determination history
Switch history view on/off
With the menu item Determinations, Show history... or the symbol only the cur-
rently focused determination in the Determination table as well as all the previous
versions of this determination will be shown.
If the history view is switched off again with the menu item Determinations, Show
history... or the symbol then the original selection of determinations in the De-
termination table will appear again.
Make old version current one
With the menu item Determinations, Make current or the symbol the determina-
tion version selected in the determination table will again be made the current de-
termination version. This creates a new determination whose version number is in-
creased by
+1 compared with the last version to have been saved.
Show calibration curve
With the menu item Determinations, Show calibration curve... or the symbol cali-
bration or standard addition curves are shown for the calibration selected in the
dialog window
Calibration curve .
Calibration curve for CAL LOOP pH
In the dialog window Calibration curve a tab marked with the command name and
showing the calibration curve and calibration data will be shown for each CAL
LOOP pH command. The command type is shown above the calibration curve. The
curve display shows the measured values and the curve calculated from these