Metrohm tiamo 1.1 Manual - Manual (Page 282)

254 Database
Scaling
Start value
1 E-8 ... [ 0.0 ] ... 1 E+8
Initial value for scaling the y-axis.
End value
1 E-8 ... [ 1000.0 ] ... 1 E+8
Final value for scaling the y-axis.
Curve
Curve color
Color selection, [ pink ]
Selection of the color for the curve line.
Symbol
Symbol selection, [ off ]
Selection of the symbol for the display of the measured values. With off the
measuring points are not shown.
Symbol color
Color selection, [ pink ]
Selection of the color for the measuring point symbol.
Smoothing
[ on ], off
Switches curve smoothing on and off. The smoothed curve will be shown
as dotted line.
Smoothing factor x axis
[ 0.01] ... 1000
Factor for smoothing on the x axis.
Smoothing factor y axis
[ 0.01] ... 1000
Factor for smoothing on the y axis.
Also show original curve
on, [ off ]
If this option is switched on then in addition to the smoothed curve the
original curve will also be shown (dotted, same color).
Options
Command type
[ DET ], MET, SET, KFT, KFC, STAT, MEAS, MEAS T/Flow, DOS
Shows the type of command for which the curve properties can be defined.
The curve properties defined by command type for the reprocessing win-
dow are saved per client.