Metrohm tiamo 1.1 Manual - Manual (Page 176)

148 Workplace
Run: Abort by error
The determination or the conditioning was stopped automatically because
of an error or not even started because of an error in the Start test.
3.7.3 Application note
On the tab Application note the Application note for the loaded method defined in
the START command is shown. This tab opens as standard in the subwindow Live
display when the method is loaded.
3.7.4 Properties
With the menu item View, Properties, Properties Live display # or the context-
sensitive menu item Properties Live display # in the subwindow itself the dialog
window Properties live display # opens.
Select the command type
Command type
[ DET ], MET, SET, KFT, KFC, STAT, MEAS, MEAS T/Flow, DOS
Selection of the command type for which the properties are to be defined in
the live display. The curve properties defined per command type are then
saved per live display window and per client.
Measured value display
on, [ off ]
If this option is enabled then the required measured values will be shown in
the subwindow
Live display .
Measured value 1...3
[ off ], Measured value, Time, Temperature, Volume (for DET)
[ off ], Measured value, Time, Temperature, Volume (for MET)
[ off ], Measured value, Time, Temperature, Volume, dV/dt (for SET)
[ off ], Measured value, Time, Temperature, Volume, dV/dt (for KFT)
[ off ], Measured value, Time, Water, Drift, Charge, Ugen, Igen (for KFC)
[ off ], Measured value, Time, Temperature, Volume, dV/dt (for STAT)
[ off ], Measured value, Time, Temperature, dMV/dt (for MEAS)
[ off ], Measured value, Time, Flow (for MEAS T/Flow)
[ off ], Measured value, Time, Temperature, Volume, dV/dt (for DOS)
Selection of the measured value for the measured value display.