Metrohm tiamo 1.1 Manual - Manual (Page 239)

Templates for curve overlay 211
4.6.2 Properties
The properties of a template for superimposed curves can be set on the following
4 register cards:
• x Axis
Parameters for the graphical presentation of the superimposed curves
on the x axis.
• y Axis
Parameters for the graphical presentation of the superimposed curves
on the y axis.
• Options
Options for the graphical presentation of the superimposed curves.
• Comment
Entry of comments for the template.
x Axis
Parameters for the graphical presentation of the superimposed curves on the x
axis.
Template name
50 characters
Name for the curve overlay template which is saved in the configuration da-
tabase per client.
Command type
Selection of command types
Selection of the command type from which curves are to be superimposed.
Autoscaling
[ on ], off
If this option is switched on then the x axis in the curve window will be
scaled automatically. In this case the fields
Start value and End value cannot
be edited.
x Axis
Quantity
Command-dependent selection
Selects the quantity to be shown on the x axis.
Label
25 characters, [ auto ]
Freely definable axis labeling for the x axis. With auto the label from the field
Quantity will be used.