Metrohm tiamo 1.1 Manual - Manual (Page 75)

Formula editor 47
The parameter can either be entered directly as a number or as a Variable
of type
Number . If the parameter does not correspond to the selected type
then it will be automatically converted to it (see Type conversion "TextTo-
Number"). If this is not possible then "
invalid " will be returned as the result of
this operation.
Examples
Abs(-55.3) = 55.3
Abs('CV.MeanTemp') = value of the Common variable without sign
Fraction
Syntax
y = Frac(number)
Returns the fractional part of the entered number.
Note
In the Result properties under Definition it is essential that the number of
Decimal
places of the result is entered, as otherwise the decimal fraction cannot be
shown.
Parameter
Number
The parameter can either be entered directly as a number or as a Variable
of the type Number . If the parameter does not correspond to the selected
type then it will be automatically converted to it (see Type conversion
"TextToNumber"). If this is not possible then "
invalid " will be returned as the
result of this operation.
Examples
Frac(-55.325) =0.325
Frac('CV.MeanTemp') = value of the Common variable without sign
Integer
Syntax
y = Int(Number)
Returns the integer of the entered number.
Parameter
Number
The parameter can either be entered directly as a number or as a Variable
of the type
Number . If the parameter does not correspond to the selected
type then it will be automatically converted to it (see Type conversion
"TextToNumber"). If this is not possible then "
invalid " will be returned as the
result of this operation.
Examples
Int(-55.325) = -55
Int('CV.MeanTemp') = integer part of the value of the Common variable