Metrohm tiamo 1.1 Manual - Manual (Page 398)

370 Method
Commands
Depending on the measured value one of the following four MET commands can
be chosen:
• MET pH
Potentiometric pH measurement with pH electrodes (measured quan-
tity pH).
• MET U
Potentiometric voltage measurement with metal electrodes (measured
quantity voltage U).
• MET Ipol
Voltametric measurement with selectable polarization current (meas-
ured quantity voltage U).
• MET Upol
Amperometric measurement with selectable polarization voltage
(measured quantity current I).
•
MET pH
Command for Monotonic Equivalence Point Titrations with potentiometric pH
measurement.
Devices
This command can be executed with the following devices which have the MET
mode:
Titrino: 702, 716, 721, 736, 751, 785, 794, 798, 799
Titrando: 808, 809, 835, 836, 855
Appearance
The command has the following appearance:
Parameters
The parameters for the command MET pH are configured in the following 7 tabs:
• General/Hardware
Parameters for devices, dosing devices, sensors and stirrers.
• Start conditions
Parameters for the measurement of the initial measured value and for
defining the conditions which have to be met at the start of the titra-
tion.
• Titration parameters
Parameters for the run of the titration.
• Stop conditions
Definitions of conditions which cause the stop of the titration.
• Potentiometric evaluation
Parameters for the potentiometric evaluation of titration curves.
•
Additional evaluations
Definition of additional methods for evaluation of the titrations curves.