Metrohm tiamo 1.1 Manual - Manual (Page 404)

376 Method
MET Upol
Command for Monotonic Equivalence Point Titrations with amperometric
measurement (selectable polarization voltage).
Devices
This command can be executed with the following devices which have the MET
mode:
Titrino: 702, 716, 721, 736, 751, 785, 794, 798, 799
Titrando: 808, 809, 835, 836, 855
Appearance
The command has the following appearance:
Parameters
The parameters for the command MET Upol are configured in the following 7 tabs:
• General/Hardware
Parameters for devices, dosing devices, sensors and stirrers.
• Start conditions
Parameters for the measurement of the initial measured value and for
defining the conditions which have to be met at the start of the titra-
tion.
• Titration parameters
Parameters for the run of the titration.
• Stop conditions
Definitions of conditions which cause the stop of the titration.
• Potentiometric evaluation
Parameters for the potentiometric evaluation of titration curves.
•
Additional evaluations
Definition of additional methods for evaluation of the titrations curves.
•
Additional measured values
Definition of additional measured values of other measuring com-
mands which are saved as additional column in the list of measuring
points.
General/Hardware
Screenshot and parameters: see DET Upol - General/Hardware
Start conditions
Screenshot and parameters: see DET Upol - Start conditions
Titration parameters
Screenshot and parameters: see DET Upol - Titration parameters