Metrohm tiamo 1.1 Manual - Manual (Page 549)

Commands 521
Track call
Monitoring
[ Measured value ], Temperature, Any
Selects the parameter for which a track is to be started if the limits are in-
fringed (
Any = either of the two parameters).
Limit exceeding
Lower limit, Upper limit, [ Any ], OK
Selects the limit infringement for which a track is to be started. With Any the
track will be started when either the upper or lower limit is infringed, with OK
the track will be started when the monitored parameter is again within the
limits (including hysteresis).
Track name
Selection of available tracks
Selects the track that is to be started automatically.
Note
If a track is called for that is already running then it will be allowed to finish and
then restarted when it is free again.
Additional measured values
Screenshot and parameters: see DET pH - Additional measured values
DOS U
Command for controlled dosing with measured value U.
Devices
This command can be executed with the following devices which have the DOS U
mode:
Titrino: 718, 736, 751, 799
Titrando: 835, 836, 842, 855
Appearance
The command has the following appearance: