Metrohm tiamo 1.1 Manual - Manual (Page 591)

Commands 563
CTRL - Properties
Command name
25 characters, [ Set lines # ]
Name of the command.
Device
Device name
Device name, [ not defined ]
Selection of a device from the device table. Only those devices being able
to execute the command are selectable. Additionally,
not defined can be se-
lected. In this case, the device name must be assigned by the user at the
start of the method.
Device type
Device types, [ Titrando ]
Display or selection of the device type. If a device is selected under Device
name , this parameter is not editable any more. The device type belonging to
the selected device is displayed instead.
If the option
not defined is selected as Device name , all device types being
able to execute the command can be selected independently from the de-
vices in the device table.
Remote box
[ 1 ] ... 4 (only Titrando, 814, 815)
Selection of remote box at which the lines are to be set.
Set lines
Output signal
Binary pattern of exactly 14 characters (0, 1,*, p), [ ************** ], signal
template
Input of the binary pattern for the output signal or selecting a predefined
Signal pattern.
The following characters can be entered:
0 = Line inactive
1 = Line active
* = Any line condition
p = Set impulse (impulse length 200 ms. If an impulse with another length
should be emitted, a corresponding template must be defined.)
The bits are always numbered from right to left:
Output 13 12 11 10 9 8 7 6 5 4 3 2 1 0
Bit 13 12 11 10 9 8 7 6 5 4 3 2 1 0
Example: ************1* sets output line 1 to active (= set), for example,
with a connected Titrino this would be a Stop command. ************0*
resets the output line to inactive.