Metrohm tiamo 1.1 Manual - Manual (Page 728)

700 Configuration
Action
If the time interval for the GLP test has expired then one of the following actions
will be triggered at both the Start test and the command sequence:
Record message
The message that the GLP test interval has expired will be saved automati-
cally in the determination.
Display message
A message appears and you can then choose whether to continue with the
run or to terminate it. If the run is continued then the message that the GLP
test interval has expired will be saved automatically in the determination.
Stop determination
The running determination will be automatically terminated. The following
message must be confirmed with
[OK] .
Balance
The parameters for a Balance are set on the following tabs:
• General
General device information such as device name, device type, serial
number, etc.
• RS232
Selects the serial interface to which the balance is connected.
• GLP
Information about GLP test and GLP monitoring.
General
Device name
50 characters, [ device type number_# ]
Name of device (can be freely defined by user).
Device type
Shows the type of device.
Program version
Shows the program version of the device.
Opens the dialog window Load new program version . This button is only ac-
tive when the device has an old program version that is not supported by
tiamo which can be updated by tiamo itself.