Metrohm tiamo 1.1 Manual - Manual (Page 402)

374 Method
• Stop conditions
Definitions of conditions which cause the stop of the titration.
• Potentiometric evaluation
Parameters for the potentiometric evaluation of titration curves.
• Additional evaluations
Definition of additional methods for evaluation of the titrations curves.
•
Additional measured values
Definition of additional measured values of other measuring com-
mands which are saved as additional column in the list of measuring
points.
General/Hardware
Screenshot and parameters: see DET U - General/Hardware
Start conditions
Screenshot and parameters: see DET U - Start conditions
Titration parameters
Screenshot and parameters: see MET pH - Titration parameters
Stop conditions
Screenshot and parameters: see DET U - Stop conditions
Potentiometric evaluation
Screenshot and parameters: see DET U - Potentiometric evaluation
Additional evaluations
Screenshot and parameters: see DET U - Additional evaluations
Additional measured values
Screenshot and parameters: see DET pH - Additional measured values
MET Ipol
Command for Monotonic Equivalence Point Titrations with voltametric meas-
urement with (selectable polarization current).
Devices
This command can be executed with the following devices which have the DET
mode:
Titrino: 702, 716, 721, 736, 751, 785, 794, 798, 799
Titrando: 808, 809, 835, 836, 855
Appearance
The command has the following appearance: