Metrohm tiamo 1.1 Manual - Manual (Page 732)

704 Configuration
Stop determination
The running determination will be automatically terminated. The following
message must be confirmed with [OK] .
Barcode reader
Note
A barcode reader has to be configured as a device in tiamo only then when its
functions for automatic data import into sample tables should be used. If a USB
barcode reader not configured as a device is connected to the PC it will be rec-
ognized in a similar way to a keyboard as being an HID (Human Interface De-
vice) and can be used for data entry in all fields.
The parameters for a Barcode reader are set on the following tabs:
• General
General device information such as device name, device type, serial
number, etc.
• Settings
Settings for the barcode reader.
• GLP
Information about GLP test and GLP monitoring.
Note
If the functions of a barcode reader for automatic data import into sample tables
should be used it must be added in tiamo as a device and cofigured so that dur-
ing each data transmission the following preamble and postamble check char-
acters are also transmitted:
Preamble #1:
02hex (^B, STX)
Preamble #2: 02hex - 09hex (different identification code 02hex - 09hex for
each connected barcode reader)
Postamble #1: 04hex (^D, EOT)
End:
Refer to the user manual of the barcode reader for its configuration.