Metrohm tiamo 1.1 Manual - Manual (Page 424)

396 Method
SET Upol
Command for Set Endpoint Titrations with amperometric measurement (select-
able polarization voltage).
Devices
This command can be executed with the following devices which have the SET
mode:
Titrino: 702, 716, 718, 719, 720, 721, 736, 751, 758, 785, 794, 798, 799
Titrando: 808, 809, 835, 836, 841, 855
Appearance
The command has the following appearance:
without conditioning with conditioning
Parameters
The parameters for the command SET Upol are configured in the following 8 tabs:
• General/Hardware
Parameters for devices, dosing devices, sensors and stirrers.
•
Start conditions
Parameters for the measurement of the initial measured value and for
defining the conditions which have to be met at the start of the titra-
tion.
• Control parameters
Control parameter for endpoint 1 and endpoint 2 (measured value for
the endpoint, titration rate, user defined parameters, stop criterion).
• Titration parameters
Parameters for the run of the titration.
• Stop conditions
Definitions of conditions which cause the stop of the titration.
•
Conditioning
Switching conditioning on/off. Definition of start drift, drift correction
and stop conditions.
•
Additional evaluations
Definition of additional methods for evaluation of the titrations curves.
•
Additional measured values
Definition of additional measured values of other measuring com-
mands which are saved as additional column in the list of measuring
points.
General/Hardware
Screenshot and parameters: see DET Upol - General/Hardware