Metrohm tiamo 1.1 Manual - Manual (Page 146)

118 Workplace
Modification comment for sample data
If the option Comments on modification of sample data is switched on in the Security
settings then before the edited sample data is accepted the window Modification
comment sample data opens first, in which a reason for the modification must be
selected and comments about the modification must be entered.
Reason
Selection from standard texts
Slection from the Default reasons defined in the dialog window Security set-
tings for the category Modification of sample data .
Comment
1000 characters
Entry of comments about the modification to the sample data.
Determination run
A determination that is started on the tab Single determination in the subwindow
Run takes place as follows:
1 - Load sample data
The Sample data entered on the tab Single determination is loaded for the deter-
mination.
2 - Select method
Method selection triggers the following actions:
• Select method without assignment ID
If the option Method selection by assignment ID is not switched on on
the tab Process then the method selected in the field Method will remain
loaded.
• Select method with assignment-ID
If the option Method selection by assignment ID is switched on on the
tab Process then the Sample assignment ID will be used to load the
method defined in the Sample assignment table .
3 - Carry out start test
During the Start test the following checks and actions are triggered:
• Right to carry out the method?
Checks whether the logged-in user has the right to execute the par-
ticular method.
• Method executable?
Checks whether the particular method is executable. If the method is
non-executable then a message appears asking for the Method test to
be carried out and the method edited accordingly.
• Check device (module) and rack
Checks whether the devices (or device types), modules (e.g. measur-
ing inputs, towers, etc.) and racks demanded in the device-specific
commands are present and available or assigned. If the device has